ASROCK H81M-VG4 R2.0 Bedienungsanleitung Seite 20

Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 14)
Power LED Header
(3-pin PLED1)
(see p.1, No. 7)
Chassis Fan Connector
(4-pin CHA_FAN1)
(see p.1, No. 13)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, No. 1)
ATX Power Connector
(24-pin ATXPWR1)
(see p.1, No. 3)
ATX 12V Power
Connector
(4-pin ATX12V1)
(see p.1, No. 18)
Downloaded from www.Manualslib.com
DUMMY
1
1
GND
+12V
CHA_FAN_SPEED
+12V
CPU_FAN_SPEED
GND
12
1
manuals search engine
Please connect the chassis
SPEAKER
speaker to this header.
+5V DUMMY
Please connect the chassis
PLED-
power LED to this header
PLED+
PLED+
to indicate system power
status.The LED is on when
the system is operating.
The LED keeps blinking
in S1 state. The LED is off
in S3/S4 state or S5 state
(power off).
Please connect fan cables
to the fan connectors and
FAN_SPEED_CONTROL
match the black wire to
the ground pin.
This motherboard pro-
vides a 4-Pin CPU fan
FAN_SPEED_CONTROL
(Quiet Fan) connector.
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.
This motherboard pro-
24
vides a 24-pin ATX power
connector. To use a 20-pin
ATX power supply, please
plug it along Pin 1 and Pin
13 13.
This motherboard
provides an 4-pin ATX
12V power connector.
H81M-VG4 R2.0
19