Montageanleitung / Installation manual EINFÜHRUNG Die W-DMX Interfaces stellen einen Durchbruch in der drahtlosen plug-and-play DMX Übertragungstechnik dar und können als Funk-DMX Sender und Empfänger eingesetzt werden. Bitte lesen Sie diese Bedienungsanleitung sorgfältig durch, um einen korrekten Betrieb zu gewährleisten. Falls Sie Fragen haben sollten oder uns Ihre Erfahrungen mitteilen möchten, können Sie jederzeit den Hersteller oder Händler per Email kontaktieren.
Neben dem W-DMX Gerät benötigen Sie einen Computer mit Windows Betriebssystem und einem freien USB Anschluss. b. USB Kabel: A – mini B, um das W-DMX Gerät mit dem Computer zu verbinden. c. Download Software (RdmPcDirector.exe), die auf der Webseite des Herstellers oder Distributors verfügbar ist.
Kanal empfängt dieses Paket und wird automatisch aktualisiert.. SEND CONFIG: Speichert die Konfigurationsdaten in die angeschlossene Lichteinheit. Ziehen Sie das USB Kabel vom PC ab und schließen Sie den W-DMX an das externe Netzteil an. Damit ist die Konfiguration des W-DMX (DMX Empfänger, RF Sender) abgeschlossen.
RF Empfänger ist unbegrenzt. ÜBERTRAGUNGSMODUS 1 : 1 Ein W-DMX empfängt das DMX Signal und sendet es via RF. Ein W-DMX mit identischer RF Kanalnummer empfängt das RF Signal und sedet es als DMX Signal. ÜBERTRAGUNGSMODUS 1 : MEHRERE Ein W-DMX empfängt das DMX Signal und sendet es via RF.
200 m in offenem Raum (abhäging von den Gegebenheiten) Spannungsversorgung: 5 VDC W-DMX RF Sender: Eingang für 512 Kanäle (fünfpolige Buchse) W-DMX RF Empfänger: Ausgang für 512 Kanäle (fünfpolige Buchse) USB 2.0 A – mini B Kabel: ...
Seite 7
Montageanleitung / Installation manual INTRODUCTION The W-DMX devices represent a breakthrough in plug-and-play wireless DMX transmission, and can be used as wireless DMX transmitter and receiver. Please read this manual carefully to ensure a correct operation. If you should have any questions, you can contact the manufacturer or the distributor by e-mail anytime.
Seite 8
The W-DMX device and a computer with Windows operating system and a free USB port. b. USB cable: A – mini B to connect the W-DMX device with the computer. c. The Downloading software (RdmPcDirector.exe), which is available on the homepage of the distributor or manufacturer.
W-DMX (RF receiver, DMX transmitter)! Otherwise the communication is not possible. 6 channels also means that 6 W-DMX systems can be used same time on same area. Nr. of transmitted channels: The same value must be set as the connected DMX controller output channel number.
Seite 10
TRANSMIT MODE 1 : 1 One W-DMX receives the DMX signal and sends it via RF. One W-DMX with the same RF channel number receives the RF signal and sends a DMX signal. TRANSMIT MODE 1 : MANY One W-DMX receives the DMX signal and sends it via RF.
DMX latency: Operating range: 200 m in open air (depends on circumstances) Voltage supply: 5 VDC W-DMX RF transmitter: Input for 512 channels (5pin connector) W-DMX RF receiver: Output for 512 channels (5pin connector) USB cable: USB 2.0 A –...