SEVEN BUSMUVS Gebrauchsanweisung

LED UV STERILIZATION BOX
Instruction manual
BUSMUVS
www.v7world.com
OVERVIEW
Open button
Control Panel
USB Power Port
Power Switch
Battery Cover
1. Remove the USB cable from inside the Sterilizer
2. Select one of the two power modes:
•
Connect the USB-C cable to the power port on the rear of the box.
•
Connect the cable into a 5V /2A power adapter OR,
•
Open the bottom battery cover and install 4 AA batteries
3. Slide the power switch to the "ON" position, and you will hear a "beep" tone
4. Operate the sterilization box indoors on a flat surface
5. If Unused for long time, open the bottom battery cover and remove 4 AA
batteries.
CONTROLS
2.
1.
1. OPEN BUTTON - Press to open cover
2. STERILIZE TIME – Press to select Sterilize time
INSTRUCTIONS
Power switch: Slide the power switch to the ON position, you'll hear
a "beep" tone.
Open button: Press the open button on the cover to insert or remove
items. When the cover is opened, the "beep" tone will repeatedly
sound
Sterilize time: Press 5 to select the 5 min quick mode. A Blue LED
confirms your selection. Press 10 to select the 10 min efficiency mode
Press 24h to select the 24h cycling mode. In this mode the LED UV
lamp works for 10 min per 1h interval for 24 hours.
Cycle finished: When sterilization is finished, you will hear 5 beeps
and the LED shuts off.
Auto Shut-off: If the cover is opened during operation, the sterilizer
will shut off. You must close the cover and select a new cycle to
resume.
Pause/Stop: You can stop the current mode by pressing the current
mode or change the mode by selecting a new mode.