Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Operating and display components
Front side
1
2
No.
Name
1
Power LED
2
RS232
3
HDMI IN
4
CTRL/UPDATE
5
HDBT OUT
6
IR IN
7
IR OUT
8
DC 24V
6. Installation
1.
Install the transmitter at the HDMI source (e. g. Blu-ray DVD) and the receiver at the presentation
device (e. g. display / projector).
2.
Connect both units with a single Cat5e/Cat6 cable. Please use a point to point connection, if possible.
3.
Connect the units with the transmitter and receiver via HDMI cable and, if needed, RS232/IR.
4.
If needed, connect IR emitters from the IR OUT ports (same with the IR receiver to the IR-In) of
transmitter and receiver and fi rmly attach the IR emitter eye directly over the infrared receiving
sensors of the source and display device to be controlled. Location of the emitter eye on each
device may need to be adjusted later to achieve best IR performance.
Connect the power supply to the transmitter or receiver and power on all devices.
Note: The maximum range can only be reached by the use of high quality cables and straight
cable runs with no electrical interference and without intermittend connectors.
We recommend to use CAT-6/CAT-7 installation cable with AWG 23 wires.
12
3
4
Description
Lights red when voltage is applied
Euroblock/Phoenix socket for sending / receiving commands
HDMI connector for connecting an input device (e. g. notebook)
Switch to defi ne the RS232 connection
• In the CTRL position, it serves as RS232 transmitter / receiver
• In the UPDATE position you can update the operating system
RJ45 jack for connecting the CAT-6/CAT-7 cable to the receiver
3.5 mm jack socket for IR receiver (receiver not included)
3.5 mm jack socket for IR transmitter (transmitter not included)
DC connector for connecting the supplied power supply
Rear side
5
6
7
8
Werbung
Inhaltsverzeichnis
