San Marina Pools AR700 Einbau- Und Betriebsanleitung Seite 4

The pump must be connected to a 220/230 V. alternating current and 50 Hz power point, with earth connection.
Consumption: 240 W.
An omnipolar switch must be used to ensure there is no power feed to the filter when it is not in use. A 30 mA differential
must also be used to protect from electrical breakdowns. (Not supplied. These items can be purchased at electricity
shops.)
4 UPPER SELECTOR VALVE
The upper selector valve is responsible for selecting the 4 different filter functions: backwash, filter, waste, and close for
the models AR700 and AR7050.
The upper selector valve is responsible for selecting the 6 different filter functions: backwash, recirculation, rinse, filter,
waste, and close for the models AR710 and AR715.
To change the valve setting, proceed as follows for models AR700 and AR7050: Fig 7
• Always disconnect the socket.
• Loosen the upper triangular knob on the valve until you can lift the cover of the housing and turn it.
• Rotate the cover until the desired setting is aligned with the discharge hose and the rib is inserted in its housing.
• Retighten the knob, but be careful not to overtighten as the internal components of the valve may be damaged.
To change the valve setting, proceed as follows for models AR710 and AR715: Fig 7
• Always disconnect the power socket.
• Press firmly on the upper valve control until the front rib is released from its housing and it can turn on its own axis.
• Gently turn the control until the front rib is aligned with the housing for the desired operation.
• Release the control gradually and check that the front rib is fully inserted in the appropriate housing.
4.1 Assembly the pressure gauge in models AR700 and AR7050
4.2 Assembly the pressure gauge in models AR710 and AR715
Downloaded from www.Manualslib.com manuals search engine
4