Herunterladen Diese Seite drucken
Philips eW Cove EC Powercore Installationsanweisungen
Philips eW Cove EC Powercore Installationsanweisungen

Philips eW Cove EC Powercore Installationsanweisungen

Werbung

eW Cove EC Powercore
eColor Cove EC Powercore
A
Must be installed by a qualified electrician in
accordance with all national and local electrical and
construction codes and regulations.
Doit être installé par un électricien qualifié conformément aux codes et
réglementations électriques nationaux et locaux du bâtiment.
Muss von einem geprüften Elektriker in Übereinstimmung mit allen
nationalen und örtlichen elektrischen Codes und Regelungen installiert
werden.
A
Before installing this product, please visit the
product page at www.philipscolorkinetics.com for the
latest version of the installation instructions. Due to
continuous improvements and innovations, installation
instructions may change without notice.
Avant de procéder à l'installation de ce produit, veuillez consulter la
page Web du produit à l'adresse www.philipscolorkinetics.com pour
obtenir les instructions de montage les plus récentes. En raison des
améliorations et innovations sans cesse entreprises, les instructions de
montage peuvent être modifiées sans préavis.
Verify electrical plan
Verificare lo schema elettrico
E Configuration Calculator: www.colorkinetics.com/support/install_tool/
Calculates the number of fixtures each circuit can support based on: model of fixture, line voltage, circuit load, and cable lengths.
Calcule le nombre d'appareils que chaque circuit peut prendre en charge en fonction des éléments suivants : modèle de l'appareil, tension secteur, charge d'une
ligne et longueurs des câbles.
Berechnet die Anzahl der Beleuchtungseinheiten, die jede Schaltung unterstützen kann, auf Basis von: Modell der Beleuchtungseinheit, Spannung, Belastung der
Schaltung, Kabellängen.
Calcular la cantidad de apliques que cada circuito puede admitir según: el modelo de aplique, la tensión de línea, la carga del circuito y las longitudes de cable.
Calcolare il numero di gruppi di illuminazione che possono essere supportati da ogni circuito sulla base dei seguenti parametri: modello del gruppo di
illuminazione, voltaggio della linea, carico del circuito e lunghezza dei cavi
Berekent het aantal bevestigingen dat ieder circuit kan ondersteunen gebaseerd op: bevestigingsmodel, lijnspanning, circuitlading en kabellengtes.
各回線でサポートできる器具数を器具のモデル、 線間電圧、 回線負荷、 およびケーブル長に基づ いて算出します
计算每个电路上可安装的灯具数量,计算依据是:灯具型号、线路电压、电路负荷和电线长度。请进入以上网址查看详情。
Mounting options
Options de montage
Befestigungsmöglichkeiten
Opciones de montaje
Opzioni di montaggio
Montage-opties
取り付けオプション
安装方案
PUB-000250-00 R04
La instalación debe realizarla un electricista calificado siguiendo todos
los códigos y normativas eléctricas y de construcción, tanto nacionales
como locales.
Devono essere installati da un elettricista qualificato in conformità con
le norme locali e nazionali vigenti in materia di costruzioni edilizie e
installazione di impianti elettrici.
Moet door een gekwalificeerd elektricien overeenkomstig alle nationale
en lokale elektrische verordeningen worden geïnstalleerd.
Besuchen Sie vor der Installation des Produkts bitte die
Produktseite unter www.philipscolorkinetics.com, um die aktuellen
Installationsanweisungen herunterzuladen. Aufgrund kontinuierlicher
Verbesserungen und Innovationen können die Installationsanweisungen
ohne Vorankündigung geändert werden.
Antes de instalar este producto, visite la página del producto en
www.philipscolorkinetics.com para consultar la última versión de
las instrucciones de instalación. Debido a las continuas mejoras e
innovaciones, las instrucciones de instalación pueden cambiar sin previo
aviso.
Prima di installare il prodotto, visitare la pagina relativa all'indirizzo
www.philipscolorkinetics.com per la versione più recente delle istruzioni
d'installazione. Grazie ai miglioramenti e alle innovazioni continue, le
istruzioni sono soggette a modifiche senza preavviso.
E www.philipscolorkinetics.com/support
Vérifiez le schéma électrique
Den Schaltplan prüfen
Check aanwezigheid van de installatieplattegrond
Instructions d'installation
Instrucciones de instalación
Installatie-instructies
Reverse-phase
ELV-type
dimmers
only
国または地域の建築コードおよび規制にすべて従い、 資格のある電
気技師が設置してください。
必须根据所有国家和地方的电气和施工准则及规范,由符合资格的
电工进行安装。
Ga voordat u dit product installeert, eerst naar de productpagina op
www.philipscolorkinetics.com voor de meeste recente versie van
de installatie-instructies. Vanwege voortdurende verbeteringen en
innovaties kunnen de installatie-instructies zonder bericht gewijzigd
worden.
この製品を設置する前に、 www.philipscolorkinetics.comの製品ペー
ジにアクセスして、 最新の設置手順を確認してください。 改善 ・ 改良
を継続的に行っているため、 取り付け手順が予告なく変更されるこ
とがあります。
安装该产品之前,请先访问产品页面 www.philipscolorkinetics.com
以获取最新版的安装说明。由于在不断地改进和创新,安装说明可
能会有所改动,恕不另行通知。
Conecte Verifique el plan eléctrico
電気配線を確認します
Mounting track
Installation Instructions
Installationsanweisungen
Istruzioni per l'installazione
インストール手順  安装指示
验证电路图
OK

Werbung

loading

Inhaltszusammenfassung für Philips eW Cove EC Powercore

  • Seite 1 Cove EC Powercore Installation Instructions Instructions d’installation Installationsanweisungen eColor Cove EC Powercore Instrucciones de instalación Istruzioni per l’installazione Installatie-instructies インストール手順  安装指示 Reverse-phase ELV-type dimmers only La instalación debe realizarla un electricista calificado siguiendo todos 国または地域の建築コードおよび規制にすべて従い、 資格のある電 Must be installed by a qualified electrician in los códigos y normativas eléctricas y de construcción, tanto nacionales...
  • Seite 2 Cove EC Powercore / eColor Cove EC Powercore Installation Instructions Make sure power is OFF Assurez-vous que l’alimentation est coupée Vergewissern Sie sich, dass die Stromzufuhr ABGESCHALTET ist Asegúrese de que la alimentación eléctrica esté desconectada Assicurarsi che l’alimentazione sia disattivata Zorg dat de voeding is uitgeschakeld 電源が...
  • Seite 3 Cove EC Powercore / eColor Cove EC Powercore Installation Instructions Connect the leader cable Branchez le câble principal Schließen Sie das Masterkabel an Enchufe el cable de alimentación eléctrica principal Collegare il cavo pilota Sluit de geleidekabel aan リーダー ケーブルを接続します...
  • Seite 4 フィクスチャを設置または配線する前に、 主電源がオフであること を確認してください。 对灯具进行安装或接线时,需确保主电源已关闭。 Copyright © 2009 – 2013 Philips Solid-State Lighting Solutions, Inc. All rights reserved. Philips Color Kinetics Chromacore, Chromasic, CK, the CK logo, Color Kinetics, the Color Kinetics logo, ColorBlast, 3 Burlington Woods Drive...

Diese Anleitung auch für:

Ecolor cove ec powercore