Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Figure 1: TST RFUxFCOM
The expansion board is only for use in FEIG Controllers. During
commissioning and operation of the used controller, the safety information as well as
installation and connection information of the assembly instructions must be
observed!
1.
General description
The TST RFUxFCOM is an interface expansion board, which provides an additional RS485
and a CAN interface.
The expansion board is mounted by different spacers and connected by the X44 and X45
connectors. All functions are unversal programmable by the controller.
The interface expansion is required to realize a master / slave operation between two
controllers, to operate the I / O expansion TST RFUxK as a remote control unit, or to get
access of a computer to the controller.
The manufacturer has carefully checked and inspected the device hardware and software,
but no warranty is given for a complete absence of errors.
FEIG ELECTRONIC GmbH
Lange Str. 4
TST RFUxFCOM
Interface expansion board
RS 485 / CAN
D‐35781 Weilburg, Germany
2.
Wiring diagram
3.
Specifications:
Dimensions:
Supply voltage:
Connection:
Operating temperature:
Storage temperature:
Power consumpition:
Enclosure rating:
Weight :
Current capacity (24VDC):
Dispose of the product at the end of its life cycle in accordance with
the applicable statutory provisions
Tel.: +49 (0) 6471 / 3109‐0
Fax: +49 (0) 6471 / 3109‐99
Figure 2: Wiring TST RFUxFCOM
( L x W x H ) 91 x 25,5 x 19 mm
24 V
+/- 20%
DC
Plug-in terminal 4 pol. green, CAN
Plug-in terminal 4 pol. yellow, RS485
-20°C to +50°C
-20°C to +70°C.
21 mA
IP 00
18 g
max. 800mA
TST RFUxF-Com Montageanleitung_2.docx
www.feig.de
Email: info@feig
Werbung
