Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LED front light adjustment
Align the LED front light so that the light beam reaches the road approx. 10 meters in front of the
wheel (see ill.).
Attention! Check regularly the correct setting of your front light. The light beam of the LED front light
must point straight in direction from 400 up to 1200mm.
Front reflector assembly (optional)
It is possible to mount a white reflector to the bottom of the front light 1.. The reflector is equipped
with two pins that adapt into the holes of the front light. Screw the reflector to the front light for a
permanent attachment.
Operation
Switch position "on"
- Front light is on, parklight function (SL) is activated
Switch position "off"
- front light is off
Switch position "auto"
- The sensor (S) located under the switch is activated. As soon as the sensor (S) recognizes
that there is not enough natural light, the front light will turn on.
Parklight function
When the front light is on, the parking light function is automatically activated. Power is supplied via
a MTF capacitor, which is fully charged after approx. 4 minutes of driving. As soon as bike stops, the
LED light stays on another 4 minutes.
Manual_Luna 40_2019-02 DE-02
Cleaning
Clean the device only with a slightly damp, lint-free cloth. Never completely immerse the device under
water. Do not use any corrosive or abrasive cleaners. This causes damage to the device.
The packaging is made of environmentally friendly materials which you can
dispose of at local recycling centers.
Throw your device if it has been used in the interests of environmental protection,
not in the household waste, but run it to a proper disposal. You can find out about
collective places and their opening times by your responsible management.
Disposal of the disused device is available at your local or city government office.
Warranty conditions
Dear Customer, You will receive a 2-year warranty on this device from the date of purchase. In the
event of defects in this product, you have legal rights against the seller of the product. These legal
rights are not limited by the warranty below.
Guarantee conditions
The warranty period begins with the date of purchase. Please keep the original receipt. This document
is required as a proof of purchase. If a defect in material or workmanship occurs within 2 years from
the date of purchase of this product, the product will be repaired or replaced by us at our discretion
free of charge. This warranty requires that within the 2-year period, the defective device and the
proof of purchase (receipt) presented and briefly described in writing, what the defect is and when it
occurred. If the defect is covered by our warranty, you will receive the repaired or a new product back.
Repair or replacement of the product does not commence a new warranty period. The guarantee time
is not extended by the guarantee. This also applies to replaced and repaired parts. Any damage and
defects already existing at the time of purchase must be reported immediately after unpacking. After
the warranty period incurred repairs are chargeable.
Warranty scope
The device has been carefully produced according to strict quality guidelines and METI-culously
checked before delivery. The warranty applies to material or manufacturing defects. This warranty
does not cover product parts that are subject to normal wear and tear and can be considered as
wearing parts or for damage to fragile components, such as switches, batteries or part made of
glass. This warranty is void if the product has been damaged, improperly used or serviced. For proper
use of the product, all instructions given in the operating instructions must be exactly followed.
Uses and actions that are advised against or warned against in the operating instructions are to be
absolutely avoided. The product is intended for private and non-commercial use only. Abusive and
improper handling, use of force and internal tampering not carried out by our authorized service
branch, the warranty will be void. If malfunctions or other defects occur, please first contact the
service department named below by phone or e-mail.
Product features
Model:
Luna 40 N+, Luna 40 N++
Article number:
51254519 / 51254520 / 51254521
Luminosity:
approx. 40 lux
Rated voltage:
6 Volt
Rated power:
1,6 Watt
SERVICE + SUPPLIER
Hermann Hartje KG
Deichstr. 120-122
27318 Hoya
Tel. 04251/811-0
www.contec-parts.com
info@contec-parts.de
Werbung
