AB Regin TM1 Anweisung

Fig 1
Dane znamionowe
Fig 2
One step room thermostat
TM1 is a single-step room thermostat with a chenge-over
relay for either heating or cooling.
TM1 may be used with the internal or an external sensor.
Installing
Remove the front cover by depressing the plastic
tonguein the middle of the lower edge with a screwdriver.
See fig 1. Mount the TM1 on the wall. The screw pockets
have a c:c distance of 60mm to fit on a wallbox.
If the TM1 is to be used with the internal sensor it should
be mounted approx. 5 ft above floor level at a location
with a representative temperature
Connect the wiring for the supply voltage, the output
and, when used, the external sensor according to the
wiring diagram. See fig 2.
Set the jumper next to the sensor terminals to the
position indicated for the choice of sensor you have
made. See fig 2.
As external sensor a Regin TG-type sensor must be
used.
Technical data
Supply voltage 230 VAC +/-15%, 50-60Hz.
Load maximum 3680W (16A).
Setting range 0 - 30°C.
Switching differential 1K.
Protection class IP30.
Wiring terminals
1. 230 VAC Supply voltage.
2. Supply common.
3. Relay common.
4. Relay heating.
5. Relay cooling.
G-G External sensor.
EMC emissions & immunity standards:
This product conforms with the requirements of
European EMC standards CENELEC EN 50081-1 and
EN 50082-1 and carries the CE mark.
LVD
This product conforms with the requirements of
European LVD standards IEC 730-1 and IEC 730-2-1.