Kathrein UFO 372/TP Handbuch Seite 19

1.7 Selecting the output level
The output level is selected using the "<" and ">" buttons.
I
27.500
Outp.
6.900
The output signal rate can be adjusted in 40 steps from level maximum ("0") to minimum ("-40") using the output channel
sub-menu.
Pressing the "Sub-menu" button
The output level is selected using the "<" and ">" buttons and adjusted using the "+" and "-" buttons.
1.8 Switching output on/off
The output channel unit is selected using the "<" and ">" buttons.
I
27.500
Outp.
6.900
The output can be switched on and off using the output channel sub-menu.
The following settings are available: on or off
Pressing the "Sub-menu" button
The output is selected using the "<" and ">" buttons and adjusted using the "+" and "-" buttons.
When the output is switched off an indicator (*) is shown in the main menu, on the left beside the output channel.
If any channel unit (I or II) is not used, its output signal must be switched off.
1.9 Selecting the output symbol rate
The output symbol rate is selected using the "<" and ">" buttons.
I
27.500
Outp.
6.900
The output symbol rate can be adjusted continuously from 2.275 MS/s to 7.150 MS/s in 0.001 MS/s steps using the "+" and "-"
buttons.
The digits can also be entered individually to a resolution of 0.001 MS/s:
• Press the "Change setting mode" button
• The fi rst digit fl ashes and can be input directly using the buttons on the keyboard
• After the fi rst digit has been input, the second fl ashes, and so on
• To make a correction, press the "Back" button to skip one place to the left
• After the last digit has been set, press the "Change setting mode" button
Downloaded from www.Manualslib.com
1236 MHz
MS/s 3/4
S21 306.00
MS/s 256
Main menu
activates the sub-menu; pressing the "Sub-menu" button again deactivates it.
1236 MHz
MS/s 3/4
* S21 306.00
MS/s 256
Main menu (output I switched off)
activates the sub-menu; pressing the "Sub-menu" button again deactivates it.
1236 MHz
MS/s 3/4
S21 306.00
MS/s 256
Main menu
manuals search engine
TP **
QPSK Frequency
MHz
Level
QAM
Output
TP
**
QPSK
Frequency
MHz
Level
QAM
Output
TP
QPSK
MHz
QAM
(starts mode)
UFO 372TP-I
306.00 MHz
0
on
"Output frequency" sub-menu
UFO 372TP-I
306.00 MHz
0
off
"Output channel" sub-menu
to end the mode
**
**