Care And Cleaning - COOLFORT CF-1226 Betriebsanweisung

• Protect the unit from heavy blows – this
can lead to damage of the unit, broken
parts or rupture of internal chain ele-
ment.
• Do not use the unit if there are visible
damages or if the power cords or the
plug are damaged.
• Do not try to repair the unit yourself,
apply to the authorized service center.
Attention!
• When using the unit moisture can ap-
pear in the cooling chamber. It does
not mean that the unit is damaged;
wipe the cooling chamber with dry
cloth.
• Long connection of the unit to the cig-
arette lighter with the dead engine can
lead to discharging of the accumula-
tor.
Operation of the unit
• The unit is intended for cooling only
food products.
• Do not open the lid without necessity.
• Lid clamp (2) in the open position is
performed by the handle (3), other-
wise the unit can overturn.
• Do not leave the lid open for a long time
if the unit is in use.
• If the carrying handle (3) is reclined,
the lid (2) is blocked (pic. 1). The lid
(2) can be open only when the carrying
handle (3) is tipped forward (pic.2).
Before switching on of the unit, wipe the
inner chamber with wet cloth.
- Insert the power plug (9) into the sock-
et of the cigarette lighter (12 V) – the
unit will start to operate.
- To switch off the unit, take the plug out
of the socket.
CF-1226.indd 5 CF-1226.indd 5
FUSE REPLACEMENT (pic.3):
- car power cord (9) has protection
from short circuit
- to replace the fuse, unscrew the
upper part of the plug
- remove and replace the fuse
- screw the upper part of the plug
Attention: do not use fuses for the
current more than 5А.
- While connecting to the mains: insert
the plug (8) into the socket (220 V).
- To switch off the unit, take the plug out
of the socket.
Attention! The unit cannot operate
from direct current power source
(12 V) and alternating current power
source (220 V) at the same time.

CARE AND CLEANING

- Disconnect the unit from its power
supply before cleaning.
- Do not clean the lid under a stream of
water.
- To remove oily strains, use a neutral
detergent.
- To remove insignificant strains, simply
wipe them with a clean damp cloth.
- To remove the strains on the inside and
outside of the ventilation openings,
use a vacuum cleaner and then wipe
the openings with a damp cloth.
MALFUNCTIONS AND THEIR SOLU-
TION
Before sending the unit in for repair,
check the following list of malfunctions:
ENGLISH
5
10.12.2009 15:17:57 10.12.2009 15:17:57