RS232
communication
AC input
1. Inspection
Remove the UPS from its packaging and inspect it for damage that may have occurred
during shipping. If any damage is discovered, repack the unit and return it to the place of
purchase.
2. Charging
This unit is shipped from the factory with its internal battery fully charged, however, some
charge may be lost during shipping and the battery should be recharged prior to use. Turn
on the UPS, Plug the unit into an appropriate power supply and allow the UPS to charge
fully by leaving it plugged in for at least 6 hours with no load (no electrical devices such as
computers, monitors, etc.) connected.
6 hours
11
Output
receptacles
EN