V-TAC VT-5050 Installationsanleitung Seite 5

Step 8: To pair the device with LED Smart Strip Light make sure the light is blinks rapidly.
Once the light blinks rapidly, the light is in pairing mode. If the light is not blinking rapidly, you
can do one of the following steps:
A. Switch the light on & off repeatedly for 3 �mes, with short intervals of less than 2 seconds.
B. Tap the 'How to make light blink rapidly' link (as shown on the image to the right)
Network Modes:
1) EZ Mode: Light flashes twice per second
2) AP mode: Slow flash, once every 2 second
Confirm if the light blinks rapidly, select the Wi-Fi network, and enter the password.
Step 7: Choose 'Ligh�ng' to start pairing the
light to the app.
4
ENGLISH