Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
About This Guide
The SlimPAR Q12BT Quick Reference Guide (QRG) has basic product information such as mounting, menu options, and
DMX values. Download the User Manual from
Disclaimer
The information and specifications contained in this QRG are subject to change without notice.
LIMITED WARRANTY
FOR WARRANTY REGISTRATION AND COMPLETE TERMS AND CONDITIONS PLEASE VISIT OUR WEBSITE.
For Customers in the United States and Mexico:
For Customers in the United Kingdom, Republic of Ireland, Belgium, the Netherlands, Luxembourg, France, and
Germany::www.chauvetlighting.eu/warranty-registration/
Chauvet warrants that this product shall be free from defects in material and workmanship under normal use, for the
period specified in and subject to the exclusions and limitations set forth in, the full limited warranty on our website. This
warranty extends only to the original purchaser of the product and is not transferable. To exercise rights under this
warranty, you must provide proof of purchase in the form of an original sales receipt from an authorized dealer that shows
the product name and date of purchase. THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES. This
warranty gives you specific legal rights. You may also have other rights that vary from state to state and country to
country. This warranty is valid only in the United States, United Kingdom, Republic of Ireland, Belgium, the Netherlands,
Luxembourg, France, Germany and Mexico. For warranty terms in other countries, please consult your local distributor.
Safety Notes
These Safety Notes include important information about installation, use, and maintenance.
•
Always connect the product to a grounded circuit.
•
Make sure the power cord is not crimped or damaged.
•
Always disconnect the product from the power source before cleaning it or replacing the fuse.
•
Never disconnect the product from the power source by pulling or tugging on the cord.
•
If mounting the product overhead, make sure there is adequate support for the product's weight
and always secure the product using a safety cable.
•
Make sure there are no flammable materials close to the product when it is operating.
•
Avoid direct eye exposure to the light source while the product is on.
•
Do not touch the product's housing when the product is operating because the housing can be very
hot.
•
The product is not intended for permanent installation.
•
The product is for indoor use only. It is rated at IP20.
•
Do not expose the product to rain or moisture.
•
Always connect the product to a power source that is within the voltage range stated on the label
or rear panel of the product.
•
Never connect the product to a dimmer or rheostat.
•
Make sure to replace the fuse with another of the same type and rating.
•
Always install the product in a location with adequate ventilation.
•
Always leave at least 20 in (50 cm) between the product and adjacent surfaces.
•
Be sure that no ventilation slots on the product's housing are blocked.
•
Do not operate the product at an ambient temperature higher than 104 °F (40 °C).
•
Never carry the product by the power cord or any moving part.
•
Always use the mounting/hanging bracket to lift the product.
•
If there is a serious operating problem, stop using the product immediately.
•
Never try to repair the product. Repairs carried out by untrained people can lead to damage or
malfunction.
•
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect from
power via breaker or by unplugging it.
Contact
Outside the U.S., United Kingdom, Ireland, Benelux, France, Germany, or Mexico, contact your distributor to request
support or return a product. Visit
SlimPAR Q12BT QRG Rev. 7
QUICK REFERENCE GUIDE
www.chauvetdj.com
www.chauvetlighting.com/warranty-registration
www.chauvetdj.com
for contact information.
for more details. Patent pending.
EN
1
Werbung
Inhaltsverzeichnis
