YBA Heritage R100 Handbuch Seite 7

Discovering your R100: Rear view Discovering your R100: Rear view
5
1 2 3 4
CAUTION
Before connecting or disconnecting any input or output always make sure your
If you have any doubt, unplug the AC cable from the power inlet.
Make sure all components connected to your amplifier are all set to off.
Neatly arrange and organize wiring to and from your R100 and to and from all your components. Separate
AC wires from audio cables to prevent hum or other unwanted noise from being introduced into the system.
Ground
1
Phono input
2
RCA audio inputs
3
4
RCA outputs 1 and 2
5
6
5 6 7
This is a terminal that facilitates the tone arm shield cable to connect directly
to the chassis of the
signal.
This input is only for use with a turntable with MM cartridge.
Connect the RCA outputs of your source to the RCA inputs of your R100. Be
sure to connect the RIGHT output of your source to the R input of your
amplifier and the LEFT output to the L input of your amplifier.
Your R100 allows the connection of 2 external, line level sources in addition
to the phono input.
Pre-amplified output. If you want to use a subwoofer, a separate power
amplifier or some active speakers, use this connection
www.ybahifi.com
Heritage R100 Streaming Music Centre Heritage R100 Streaming Music Centre
8 9 10 11 12 13
R100 to eliminate any radio interference or hum from the
14 15
R100 is in the OFF position.
P 7