DOMUS LINE RC3 Installationshandbuch Seite 6

Setting TW mode operation
If the channel has already been set to dimmer / RGB
mode, follow steps 1 and 2. If it has already been set in
the TW channel, skip steps 1 and 2.
1
yellow blue yellow blue
2
3x
ON-OFF
General for all channels
.....
Short press: Press to change the colour temperature change mode
Flash mode:
Fade mode :
Long press:
Colour change
Long press: store scene 1
Short press: recall scene 1
Long press: store scene 2
Short press: recall scene 2
Long press: store scene 3
Short press: recall scene 3
INSTALLATION MANUAL
between flash mode and fade mode
the colour temperature of the lamp changes
without fading (hot, neutral, cold)
the colour temperature of the lamp attenuates
gradually from one colour hue to the other
Hold this button down and press "Dimmer" to select the
colour temperature change speed
+ ↑
fast =
slow = + ↓
Long press: store channel 1
Short press: recall channel 1
Long press: store channel 2
Short press: recall channel 2
Long press: store channel 3
Short press: recall channel 3
DIMMER:
Press: to increase brightness
to decrease brightness
EN