Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before Installation
Before the installation of the controller card, let us make the following assumptions:
1. The end users must have the basic knowledge of installing an internal device
and its driver to a PC. If they are not sure about their abilities or have any
queries, please call their local dealers immediately, or find somebody who are
experienced and qualified for assistance.
2. The computer has been properly installed with the supported operating system.
Installing the Controller Card into the Computer
1. Turn off your computer and all external devices connected to it.
2. Disconnect your computer from the power sources.
3. Open the computer case. Refer to your computer user manual for more details.
4. Find an available PCI-Express x1 slot and remove the slot bracket. Save the
bracket screw for later use.
5. Align the controller card horizontally with respect to the slot and insert it into the
slot firmly and evenly. Take care not to force it into the slot. Once you have
properly positioned the controller card into the slot, fasten it to the computer case
with the screw you have just saved.
6. Connect the system to network by inserting the 8-cored CAT-5 cable (not
included in the package) into RJ45 connector on the network controller card.
7. Secure the computer case and switch on your computer.
Installing Windows Driver
1. Turn on the computer.
2. Once Windows is running, a new network controller card is detected.
3. If the Windows asks for driver for the network controller card, then insert Driver
CD into the optical drive (
4. Browse to the following path (Assume the Windows OS used is Windows 7)
D:\ Realtek\RTL8111\Windows 7
5. Execute "setup.exe" to install the driver.
6. Follow the on screen instructions until the driver is totally installed.
Checking the status of the installed driver
1. Right click on the icon of My Computer and choose Properties
2. Choose Device Manager
3. Left click on the "+" sign of the Network Adapters
4. The following device should be shown:
Realtek PCIe GBE Family Controller
5. Right click on the device above and choose Properties
Assume the optical drive letter is D:)
.
Werbung
