Introduction; Installation Instructions - Cisco Systems Linksys BUSINESS Serie Bedienungsanleitung

Chapter 1
Chapter 1:
Connect the Transcever

Introduction

Thank you for choosing the MiniGBIC SFP Modules . These Modules insert
into the MiniGBIC ports on Linksys switches . Each MiniGBIC SFP Module
is hot-swappable, meaning you can connect them even when the switch
is running .
Use the following directions for installing and removing either the
MFEFX1 or the MMFELX1 .

Installation Instructions

1 .

Downloaded from www.Manualslib.com
WARNING: Optical SFPs use a small laser to generate the
fiber-optic signal . Because invisible laser radiation may be
emitted from the aperture of the port when no fiber cable is
connected, avoid exposure to laser radiation and do not stare
into open apertures . Keep the optical transmit and receive
ports covered whenever a cable is not connected to the port .
Insert the MiniGBIC SFP Module with the printed side up and the
rubber port cap facing out .
manuals search engine
Insert the Module
MnGBIC SFP Transcevers