Connection Test - Laserworld Net-19 Handbuch

PC, otherwise no communication could be possible.
As subnet mask use 255.255.255.0.
The values 'standard gateway' and the DNS-server addresses are not necessary.
Important: The manual IP-address of Net OEM (DIP-Switch) will be loaded by the card at power-
on only. So it must be set before switching on Net OEM!
Be sure the same subnet address 0 or 1 (third number of IP) is set at Net OEM and the PC.
Otherwise, no connection is possible.
2.3

Connection test

To check if a network connection is established between Net OEM and the host PC, start your web
browser and type in the IP-number of Net OEM in the web address field.
A startup page should be displayed now. This page contains some information about the network
address, MAC-address and firmware version of Net OEM.
If no start page is displayed or if no web browser is available, you can also check the connection
using the command line level.
Type in ping 192.168.0(or1). plus the card address 100 to 115 and press <Return>:
7