Fuse Replacement; Voltage Selection - HH Tensor serie Handbuch

7. MAINS INLET SOCKET AND FUSE:
IEC input for connection of an appropriate
mains lead. Only replace the fuse with the
type indicated on the rear panel.
8. MAINS SWITCH: Turns the system
on and off. Ensure the Volume control is
set to minimum when switching ON and
OFF.
9. VOLTAGE SELECT SWITCH:
Although every effort has been made to
select the correct voltage for the region of
use, please check before powering up for
the first time. Damage could occur if
the voltage is incorrectly set. See below
for more information.
10. INFORMATION: Area relating to
the amplifier: Serial Number, operational
information, power rating, etc.
11. AIR VENTS: These are critical for the
longevity and reliability of the amplifier - DO
NOT BLOCK. The same applies to the vents
at the top of the control panel.
Switch off and disconnect the power cord before proceeding.

FUSE REPLACEMENT

1. Slide out the fuse holder tray.
2. Only replace fuse with the same
type and power rating as specified
on the rear panel.
4
10
WWW.HHELECTRONICS.COM
DESIGNED AND ENGINEERED IN THE UK
WWW.HHELECTRONICS.COM
7
MODEL: TRE-1201

VOLTAGE SELECTION

110-120V setting
220-240V setting
Using a suitable tool, slide the voltage
selector switch to the required operating
voltage.
8
9
11