Technical Data - Hair Genie 2395 Gebrauchsanleitung

4. The charging process begins. The light flashes. When the battery is
fully charged, the light turns off.
5. First unplug the USB power adapter from the socket, then disconnect
the USB cable from the device.
Use
1. Remove the protective cap from the device.
2. Press the on/off switch. The device and its light (3) turns on.
3. Place the razor heads on the skin and guide them against the
direction of hair growth. Tip: Smooth the skin with your free hand to
achieve the cleanest possible result. Move the appliance slowly. Do
not press on the skin!
4. After use, press the on/off switch again to switch off the device.
5. Charge the battery when the light flashes (see chapter "Charging the
Battery")
Cleaning and storage
NOTE: The appliance must be switched off during cleaning.
1. Press the release button and open the collecting container. Dispose of
the accumulated hair.
2. Use the cleaning brush to thoroughly brush off the collecting
container and the razor heads.
3. Close the collecting tray. It must engage.
4. If necessary, wipe the housing with a damp cloth. Then dry off.
5. Place the protective cap on the razor heads.
12

TECHNICAL DATA

• Item Number: 2395
• Operating voltage: 3.7 V DC (Lithium battery, 800 mAh)
• Charging voltage: 5 V DC
• Power: max. 2 W
• Interface: Micro USB
• Battery life: up to 3 hours (with full battery)
• Battery life: up to 3 hours
• Protection class: III
DISPOSAL
The packaging material is recyclable. Dispose of the
packaging in an environmentally friendly manner and return
it to the recycling collection. Dispose of the fresh storage cans
in an environmentally friendly manner. Further information
can be obtained from your local municipal administration.
This device is subject to the European Directive for Waste
Electrical and Electronic Equipment (WEEE). Do not
dispose of the device as normal household waste, but in an
environmentally friendly manner via an officially approved
disposal company.
Batteries must be removed from the remote control before
disposing of the device and returned separately from the
device to the appropriate collection points.
13