Werbung
EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
» Care and Safety advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check against the list of contents.
•
For safety purposes we strongly recommend that the product will be assembled
by at least two people.
•
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the Gazebo in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them away from children's reach.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, ensure that you are following the
manufacturer's safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Keep roof and gutters clean of snow, dirt & leaves.
•
Heavy load of snow on roof can damage the Gazebo making it unsafe to
stand below or nearby.
•
This product was designed and produced for it's aimed purpose only.
If color was scratched during assembly it can be fixed with the following tints:
Grey – RAL 7012
» Cleaning instructions
In order to clean the Gazebo, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
» During Assembly
During assembly use a soft surface below the parts
to avoid scratches and damages.
» You will need
(Supplied)
5mm
10mm
3/16"
25/64"
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Step 7:
•
It is recommended to use a carton or other soft material under the lowered
corner in order to avoid scratches and peeling of paint.
*This note also refers to steps 8,9,10
Steps 10a+12a:
•
Please note that threading of the screws should be done from the outside
Steps 11b+13a:
•
Please note that threading of the screws should be made from the bottom up.
Afterwards please use a screwdriver for easy screwing
Step 14b:
•
Please add silicone on the inner area of part # 7661 as illustrated
Step 20a:
•
Please drill holes in the panels to be located precisely parallel to the holes in
profiles # 7744 + # 7743
Step 21:
•
Please level the profiles' legs and adapt screws and plugs to your specific ground
type.
Please note: Screws and plugs are not supplied*
•
Please Fasten all screws at the end of assembly
SILICON \
13mm
CAULK
(These items are
not supplied)
Werbung
