Battery Safety Information - Avermedia AVerTV DVB-S Pro Schnellinstallationsanleitung

AVerTV DVB-S Pro
5. VOL▲/▼
6. FULL SCREEN
7. AUDIO
8. ► (Play)
9. ■ (Stop)
10. (Forward)
11. SLEEP
12. MENU
13. EPG
14. WAKE UP
15. TELETEXT
16. TIMESHIFT/Pause
17. (Rewind)
18. ● (Record)
19. MUTE
20. CH ▲/▼
21. SNAPSHOT
22. DISPLAY
23. SOURCE

Battery Safety Information:

- Store the batteries in a cool dry place.
-
Do not dispose of used batteries in domestic waste. Dispose of batteries at special collection points
or return to point of sale if applicable.
-
Remove the batteries during long periods of non-use. Always remove exhausted batteries from the
remote control. Battery leakage and corrosion can damage this remote control, dispose of batteries
safely.
-
Do not mix old and new batteries.
-
Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium).
-
Do not dispose of batteries in a fire. The batteries may explode or leak.
-
Never short circuit the battery terminals.
ENG-4
Increase/decrease the volume.
Display TV in full screen.
Switch between available languages.
Play the last recorded or played file.
- End the Playback or recording.
- End the TimeShift mode and return to real-time TV or Radio mode.
- Advance the playback.
- Jump to the teletext page of the corresponding color according to this button.
- Go to the next file in the playlist.
- Set the time to put your computer in Standby or Hibernate mode.
- Jump to the Teletext page of the corresponding color according to this button.
Display or hide the Control Panel.
Launch the Electronic Program Guide.
- Go to the previous file in the playlist.
- Set the time to bring your computer out of Standby or Hibernate mode.
- Jump to the teletext page of the corresponding color according to this button.
View Teletext / MHEG-5 / Closed Caption information.
- Freeze the playback.
- Switch from real-time TV or Radio to TimeShift mode.
- Rewind the playback.
- Jump to the Teletext page of the corresponding color according to this button.
Switch to DVR mode and record the current program or video into your hard drive.
Turn on/off the sound.
Go up or down to the next active channel.
Capture the on-screen image to a bitmap file.
Display information.
Switch between available signal sources.