Raco 13060 Bedienungsanleitung
Bremspedaldruckmesser
BRAKE PEDAL FORCE INSTRUMENT
User guide
Cabinet dimensions LxWxH [mm] 150x80x30mm, Weight 0.58 kg.
1. Preparation for test:
•
Remove the cover from the back of the display unit and insert 1 pc. 9V batterie,
type 6LR61.
•
Mount the pedal pressure sensor on the brake pedal with the black side facing up
and attached with the rubber strap.
•
Set the switch to position 1 and the display shows "000". If another value is
shown, turn the adjusting screw, until the correct value is obtained.
2. Measuring:
When the pedal pressure sensor is used, the current pedal pressure is shown. If the
switch is moved to the "Measure Hold" position, the display shows and maintains the
highest pressure measured during the test.
3. Maintenance:
When the display shows "LOBAT", the batterie should be replaced.
The pictures are illustrative and may vary from the originals.
Bremsepedal-trykmåler
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk
13060
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk
Inhaltszusammenfassung für Raco 13060
- Seite 1 "Measure Hold" position, the display shows and maintains the highest pressure measured during the test. 3. Maintenance: When the display shows "LOBAT", the batterie should be replaced. 13060 The pictures are illustrative and may vary from the originals. RACO A/S RACO A/S...
- Seite 2 3. Wartung: Wenn das Display "LOBAT" anzeigt, sollten die Batterie ausgetauscht werden. Billederne er illustrative og kan afvige fra originalerne. Die Bilder sind illustrativ und können vom Original abweichen. RACO A/S RACO A/S Overgade 4 Overgade 4 DK 6670 Holsted DK 6670 Holsted Tlf.