Neriox 111456 Bedienungsanleitung Seite 3

3
111456
PLASTIC DIGITAL CALLIPER GAUGE
Operating instructions
2
1
Legend:
1. Measurement surfaces for outside measurement
2. Measurement surfaces for inside measurement
3. LCD display
4. mm/in key, mm/inch conversion
5. ZERO key for resetting display to zero
6. Measurement rail
7. Depth gauge
8. Battery compartment
Safety-relevant information
• Use calliper at permissible temperature only
• Protect calliper against liquids and moisture
• Protect calliper against mechanical damage
• Properly dispose of calliper
Repair
If the instrument is defective, please contact our
service centre → Servicecenter@brw.ch
Brütsch/Rüegger Werkzeuge AG, Heinrich Stutz-Strasse 20, Postfach, CH-8902 Urdorf, Tel. +41 44 736 63 63, Fax +41 44 736 63 00, www.neriox.tools, sales@brw.ch
3
4
8
5 6
Specification
Measurement range: 150 mm
Resolution: 0.1 mm
Operating temperature: 0...40°
Energy: Lithium battery CR2032 / 3.0 V
Properties
LCD display
mm/inch conversion
Resetting to zero in any position
Automatic shutdown
Made of lightweight plastic
Operation:
Activation
Deactivation
Resetting display to zero – briefly press ZERO key
mm/inch conversion
Instructions for care:
Keep the measurement rail clean. A soft cloth can be used for cleaning the surfaces.
Do not use petrol, acetone or isopropanol for cleaning under any circumstances.
Remove the battery if the instrument is not going to be used for an extended period.
– move measuring saddle
– automatic shutdown after 5 minutes
– briefly press mm/in key
7