How To Use - clearaudio electronic Syncro Power Generator SPG Bedienungsanleitung

2. How to use

Note:
DO NOT use units requiring more than 8 watts.
Although the clearaudio
cord) it is recommended to keep it far enough away from phono cartridges, phono cables and phono
preamps.
On the back panel of the clearaudio
The power is ON, when this main switch is in position ON (I).
Please make sure, that the power switch is in the "OFF" position before installing the primary AC
power cord !
On the front panel you will find three switches:
ON/OFF
Power output
On = bottom pressed
and a blue LED will
light
When the set-up is completed, switch mains to "ON" position on rear panel, and next front panel to
power "ON". The centred blue LED should light.
The central display can be switched between output "Voltage" and output "Frequency". Corresponding
blue control LED light in "Frequency" or "Voltage" position.
Slide-switch for output
voltage
Between 115/230 V
Slide-switch for input voltage
between 115/230 V
Fuse: 230 V T 0,125A
115 V T 0,25A
If you change the input voltage you also
must change the output voltage inside the
Syncro (look at picture 1) to the same
value!
Seite/Page 3
Syncro Power Generator
The clearaudio SPG was designed for a
maximum peak power of 8 watts.
Syncro (SPG)
unit can be placed anywhere (within the limits of the power
Syncro (SPG)
Output "Voltage" or
Output "Frequency"
User manual / Bedienungsanleitung
is the mains ON-OFF switch (ON = I, OFF = 0).
Picture 1
Picture 2
 clearaudio electronic GmbH 2010
Change between
channel 1 (50 Hz) and
channel 2 (70 Hz)