Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Putting into operation
Use the appliance 1-2 times with clear water prior
to first use. Put the clean bottles - their opening
showing to the top - into the pan. Depending on
the size of the bottles, 6 bottles at maximum can
be held in it. Place the teats and closing elements
in the interspaces.
Measure 80 ml fresh water with the baby bottle
and pour it into the heating pan. Then put the con-
tainer on the bottom part of the appliance and
close it with the lid. Connect the appliance to the
mains supply and switch it on. The red control
lamp indicates the beginning of the heating process.
After 15-20 min. the disinfection process will be
finished, the heating will be switched off automati-
cally and the green control lamp indicates the
beginning of the drying process, in which the
appliance heats up in short-time intervals.
After another 10 minutes, please switch off the
appliance and lift the lid a little in order to accele-
rate the drying of the bottles. Caution, danger of
the hot steam.
The remaining condensative water never influen-
ces the sterility. In the case you have extremely
hard water, there may be some milky chalk depo-
sits on the bottles. The use of decalcified water
will avoid this.
Cleaning and maintenance
Pull the plug and cool the appliance. Do not
immerse the appliance in water, but wipe with a
damp cloth to which a dishwashing agent has
been added and then wipe dry.
Do not use sharp and abrasive cleaning agents.
The cooking tray is made of stainless steel. If rust
spots are seen regardless, these are initially only
deposits adhering to the surface. They should be
removed immediately with stainless steel cleaner.
6
Decalcification
Calcium deposits result in energy losses and
reduce the service life of the appliance. It swit-
ches off early, if the calcium coating is too thick. It
is then difficult to remove. Decalcify the pot routi-
nely.
We recommend using durgol
effective and gentle to materials.
You may obtain it where you bought the applian-
ce; directly from a select dealer or you can order it
directly from petra-electric.
Disconnect the appliance from the socket and let
cool prior to decalcification. Fill in 1 to 2 cups of
®
durgol
express and let the appliance stand until
the calcium coating is removed from the bottom.
Then fill the appliance with cold water past the
calcium edge and let stand for 15 minutes. Then
pour it out and thoroughly rinse with cold water.
Do not heat the solution during decalcification.
Caution, warranty compensation does not exist
for damages that occur due to non-compliance.
For UK use only
•
This product is supplied with a 13 A plug confor-
ming to BS 1363 fitted to the mains lead. If the plug
is unsuitable for your socket outlets or needs to be
replaced, please note the following. If the plug is a
non-rewireable one, cut it from the mains lead and
immediately dispose of it. Never insert it into a
socket outlet as there is a very great risk of an elec-
tric shock.
•
The replacement of the plug at the mains lead has
to be done according to the following instructions:
Warning - This appliance must be earthed.
Important: The wires in this mains lead are colou-
red in accordance with the following code:
green/yellow:
Earth
blue:
Neutral
brown:
Live
®
express. It is very
Werbung
Inhaltsverzeichnis
