Petra electric CoolCurl CC 450 Gebrauchsanweisung Seite 9

considerable hazards for the user.
Settings
Use the slide switch to adjust the heat and air
setting individually.
C
Cooling mode
2
Maximum heat output
1
Minimum heat output
0 Appliance is switched off
If the air outlets are covered or if they are blo-
cked with hair, the emerging air will get too hot
and the overheating protection will switch off
the appliance. In this event, set the switch to
-0-. After about 5 minutes the curling tong can
be put into operation again. If necessary, clean
the appliance when unplugged prior to starting
up again.
Brush attachments
Styling brush 19 mm Ø ’ for small curls
Styling brush 23 mm Ø ’ for medium-sized
curls
Select the brush which suits the hair length
or the style you wish to create. To change the
brush, wait for the appliance to cool down,
press the roll-out button and pull off the brush
with a slight twist. Insert the new brush until it
locks into place.
After rolling in the hair, allow the heat to work
on the hair for a few seconds. If the warm air
feels too hot, select a lower setting. To roll out
the curls, press the roll-out button. The brush
will be disengaged and can be rolled out of the
formed curl.
Do not comb or brush the hair before it is com-
pletely cooled. This will ensure that the curls
hold longer.
DE
GB
9