Inhaltsverzeichnis
Werbung
Anleitung NLW 90-2 SPK1
GB
1. Layout (Fig. 1-4)
1
Laser unit
2
Base for rough surfaces
3
ON/OFF switch
4
Laser beam outlet
5
Spirit-levels
6
Battery compartment cover
7
Safety cover
8
Control buttons
9
Nails
10 Photographic tripod thread (1/4")
2. Safety information
Achtung Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation nach
EN 60825-1: 1994+A1: 2002+A2: 2001
Laser Klasse 2
JG-21
P: ≤ 5 mW
Ï: 650 nm
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
3. Use (Fig. 5)
This laser level unit is used to establish and check
horizontal and vertical lines.
6
08.09.2006
10:17 Uhr
Seite 6
4. Technical data
Accuracy
Operating temperature
Laser class
Laser wave length
Laser output
Laser power supply
Weight
5. Starting up the laser unit (Fig. 1/2)
Inserting and changing batteries (Fig. 2)
Important! Always make sure that the laser is
switched off before you insert the batteries!
Open the battery compartment cover (6) as shown in
Fig. 2 and insert the batteries supplied. Check that
the battery terminals are positioned correctly.
Use only alkaline-manganese batteries. Do not mix
batteries from different manufacturers. Use batteries
with the same capacity.
Switching on (Fig. 1): To switch the laser on, press
the On/Off switch (3) once.
Switching off (Fig. 1): To switch the laser off, press
the On/Off switch (3) twice.
Operation (Fig. 1/3)
The laser projects a horizontal line. The laser can be
held in your hands or be placed with its magnetic
mount on the base for rough surfaces (2). Exact
alignment on the base for rough surfaces (2) is
facilitated by the three spirit levels (5).
6. Working with the base for rough
surfaces (Fig. 3/4)
Remove the safety cover (7) and place the base for
rough surfaces (2) on a suitable surface and firmly
press the two control buttons (8) simultaneously.
Four nails (9) then emerge at the back and can be
used to fasten the base to the surface.
The base for rough surfaces can also be mounted on
a photographic tripod. For this purpose there is a
1/4" thread (10) on the rear.
± 0.6 mm/m
-1-40°C
2
650 nm
≤ 5 mW
2 x 1.5 V (AAA)
0.16 kg
Werbung
Inhaltsverzeichnis
