Akai Professional IB-4ADT Adat Bedienungsanleitung

Thank you for your purchase of the IB-4ADT adat
tal Interface Board for the Z4/Z8 samplers/MPC4000
Music Production Center.
This interface board is made exclusively for the Z4/Z8
Samplers/MPC4000 Music Production Center to handle
the 2-channel digital input and 8-channel output signal
with other digital equipment in adat format.
Refer to the Z4/Z8, MPC4000 Operator's Manual for the
details of operation.
Note: The IB-48P 8-Individual Output Board cannot be
installed at the same time (Z4/Z8 only).
Installing the IB-4ADT
The self-installation may cause the malfunction and/or
damage to your equipment. Refer installing of this board
to your AKAI professional dealer where you purchased or
AKAI professional service center.
<To Service Technicians>
Install the IB-4ADT to the Z4/Z8, MPC4000 following the
procedures below. Be sure to unplug its power cord be-
fore installing the board.
! Components
IB-4ADT adat Interface Board ................................. 1
Mounting Post (Short, MPC4000) ........................... 1
Mounting Post (Middle, Z4/Z8) ................................ 1
Mounting Post (Long, MPC4000) ............................ 2
8-pin Connecting Cable .......................................... 1
Fixing Screw (black, Z4/Z8) .................................... 1
Fixing Screw (gold, MPC4000) ............................... 2
Instruction Sheet ..................................................... 1
Z4/Z8
Mounting Post(M)
P4
IB-4ADT
IB-4ADT
adat Digital Interface Board for Z4/Z8/MPC4000
! Installation - Z4/Z8
TM
Digi-
1. Remove the fixing screws of the Z4/Z8 Top Cover on
its sides (2pcs. on each side) and its back center (1pc.)
and remove the Top Cover. If the Handles are used,
remove their fixing screws and then Handles.
2. Remove the fixing screws (4pcs.) for the Mask Plate
on the Rear Panel and remove the Mask Plate. Save
the screws for later use. The Mask Plate is not used.
3. Referring to the illustration, remove the fixing screw
(1pc.) on the I/O board and install the Mounting Post
(M) in its place. Save the screw for later use.
4. On the Z8 or Z4 with IB-4D SP-DIF Digital Interface
Board installed, remove its fixing screws and take the
board out. Leave the connection cable connected.
5. Connect the cable from the IB-4ADT board to the con-
nector (P4) on the I/O board.
6. Set the IB-4ADT on the Rear Panel and Mounting Post
(M) and fix it securely with the screws removed in ear-
lier steps and the fixing screw (black) included.
7. Replace the IB-4D board back and connect the 8-pin
Connecting Cable included between the IB-4D and IB-
4ADT boards.
8. Replace and fix the Top Cover (and Handles) to com-
plete the installation.
Be sure to fix the screws and connectors securely to
avoid malfunctioning.
IB-4D
Digital I/O Board
8pin Connection Cable
IB-4ADT