Troubleshooting - AKG PS 61 Bedienungsanleitung

Problem
1. No sound:
2. No or poor reception on individual
channels:
3. Green status LED on booster
antenna does not light:
4. One of the Power Splitter ERROR
LEDs illuminates:
Possible Cause
1. AC adapters of receivers connected to
channels 1 and 2, PSU 01 power
cable, or feeder cable from PSU 01 to
Power Splitter are not plugged in or
make poor contact.
2. AC adapters for channels 1 and 2 or
PSU 01 power cable defective.
3. Antennas not connected to Power
Splitter.
4. PSU 01 defective.
1. Transmitter and/or receiver switched
OFF.
2. Transmitter batteries down.
3. AC adapter of receiver or feeder cable
from PSU 01 to receiver
a) makes poor contact or
b) is defective.
4. Transmitter and receiver of dead
channel are tuned to different
frequencies.
5. Transmitter or receiver defective.
1. Antenna cable not connected or
makes poor contact.
2. Antenna cable defective.
3. Booster antenna defective.
Booster antenna receives no supply
voltage.

6 Troubleshooting

Remedy
1. Connect AC adapter or power cord to
AC power and feeder cable to PSU 01
and Power Splitter, or check all
connectors for secure contact.
2. Replace AC adapters for channels 1
and 2 or PSU 01 power cord.
3. Connect antennas.
4. Contact your nearest AKG dealer.
1. Switch transmitter and/or receiver ON.
2. Replace transmitter batteries.
3. a) Check AC adapter or feeder cable
connectors for secure fit or
b) replace AC adapter or feeder cable.
4. Tune transmitter and receiver to the
same frequency. Refer to the trans-
mitter and receiver Instruction Manual.
5. Contact your nearest AKG dealer.
1. Connect antenna cable or check
connectors for secure fit.
2. Replace antenna cable.
3. Contact your nearest AKG dealer.
Refer to section 4.4 ERROR LEDs.
10