Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Troubleshooting
* When the DVD-ROM drive does not work with the
hard disk drive in primary IDE channel.
(SOLUTION)
1. Check the DVD-ROM drive Master/Slave Jumper
setting.
The DVD-ROM drive should be set to the Slave
mode if it is on the same IDE cable as your Hard
Drive that is set to the Primary Master mode.
2. Check to be sure your hard disk Interface type is
IDE type.
3. Check your hard disk Master/Slave Jumper setting.
Some old-version IDE type hard disks were set to
Master Only mode.
In that case, contact your hard disk company and
change your hard disk jumper setting to master
mode.
4. If the DVD-ROM drive does not work with above
methods, you may need a secondary IDE card.
If you use the secondary IDE card, you should set
the DVD-ROM drive jumper to the master mode if
the DVD-ROM drive is the first device you are
connecting to the secondary IDE card.
* When the DVD-ROM drive does not install in OS/2
warp.
(SOLUTION)
1.Select NON-LISTED IDE CD.
* DVD-ROM drive is not present in Windows 3.1 or
3.11 or DOSSHELL.
(SOLUTION)
1. When the WIN or DOSSHELL command lines are
present in your AUTOEXEC.BAT, make sure that
the MSCDEX.EXE command line appears before
the WIN or the DOSSHELL command lines.
Please Note: Since this product supports Region
Playback Control Phase II, a certain MPEG decoder
card or Software without regional code setting may
cause this drive not to read DVD-ROM discs.
This DVD-ROM Drive enables you to change the
regional code up to 5 times.
Important Precautions
Follow these precautions when handling the drive or
discs.
Precautions
• Please take notice that the manufacturer of this
equipment does not offer any warranty against data
loss due to inappropriate installation or handling or
direct or indirect damages.
• Please take notice that the manufacturer will bear
no responsibility for direct or indirect damages
caused by the use of this product or its malfunction.
• Please take notice that the manufacturer will bear
no responsibility for damage to data caused by this
product.
Installation
• Avoid placing the drive in a location subject to:
- high humidity
- high temperature
- excessive dust
- mechanical vibration
- direct sunlight
We recommend using the drive in a horizontal or
vertical position. Do not install the drive at an angle.
Operation
• Don't move the drive suddenly from a cold place to
a warm one or raise the room temperature suddenly.
Condensation may occur, causing abnormal
operation.
• Make sure to remove the disc before moving the
drive. The disc may be damaged, causing data loss.
• Be careful to prevent foreign objects, such as liquids
or metal, from entering the drive. In case a foreign
object enters the drive, please consult the dealer
where the drive was purchased.
• Don't interrupt the electric power while the drive is
operating.
• When connecting two IDE devices to the Primary or
Secondary connectors, make sure that the two
devices are not configured as both Master, or both
Slave. If they are both set the same, Windows may
fail to run or recognize the drives.
Werbung
Inhaltsverzeichnis
