Headphones Connection; Radio Operation - LEXIBOOK SPIDER-MAN RCD10SP Handbuch

1. Volume control
2. LED display
3. Power indicator
4. FM Stereo indicator
5. Function selector (CD/ RADIO/ AUX/ POWER OFF)
6. Left speaker
7. Right speaker
8. Repeat indicator
9. Play indicator
10. CD door
11. FM antenna
12. Carrying handle
13. Stop button
14. F.FWD button
15. PLAY/PAUSE button
16. Radio scale
17. REW button
18. Program button
19. Repeat button
20. Band selector (AM/FM ST. /FM MONO)
21. AC jack
22. Battery compartment
23. Headphones jack
24. LINE OUT jack
25. AUX IN jack
26. Tuning control
27. Microphone jack

HEADPHONES CONNECTION

Plug any normal headphones (not included) with a 3.5mm jack plug into the headphones jack located
at the back of the unit. When the headphones are in use, the speakers are turned off.
CAUTION: Too high volume, especially when using headphones, can damage your hearing. For this
reason, please turn the volume down before connecting the headphones.

RADIO OPERATION

1. Slide the function selector to the radio position to turn the unit on.
2. Slide the band selector to select AM, FM ST (stereo) or FM Mono for the desired radio band.
3. Use the tuning control to select the desired radio station.
4. Adjust the volume control.
5. To switch off the radio, slide the function selector to the POWER OFF position.
Note: To ensure maximum FM tuner sensitivity, the FM wire antenna should be fully extended to
obtain the best possible reception. Avoid close proximity to the speakers and other electrical
appliance. For FM stereo reception, the FM stereo indicator will light steadily when a stereo program
is being received. When tuning in AM reception, to ensure best AM sensitivity, try repositioning the unit
until the best reception is obtained.
1
RCD10SPIM0088.indd 16 26/2/08 15:32:44