ImportAppliances LF457CA60 Montageanleitung Seite 11

Prior to installation
For optimum extractor hood efficiency:
Short, smooth air exhaust pipe.
As few bends in the pipe as possible.
Diameter of pipe to be as large as
possible and no tight bends in pipe.
If long, rough exhaust-air pipes,
many pipe bends or smaller pipe
diameters are used, the air extraction
rate will no longer be at an optimum
level and there will be an increase in
noise.
Round pipes:
We recommend
Internal diameter: 150 mm (at least
120 mm).
Flat ducts must have an internal cross-
section that equates to that of round
pipes.
There should be no sharp bends.
l 120 mm approx. 113 cm
l 150 mm approx. 177 cm
If pipes have different diameters:
Insert sealing strip.
For exhaust-air mode, ensure that
there is an adequate supply of fresh air.
Connecting a l 150 mm exhaust-air
pipe:
Mount the pipe directly onto the air
outlet on the hood.
Connecting a l 120 mm exhaust-air
pipe:
Place the reducing connecting piece
onto the air connecting piece – Fig. 3 –
and fasten the exhaust pipe to it.
10
2
2
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Circulating-air mode
With activated carbon filter if exhaust-air
mode is not possible.
If the extractor hood is suitable for
circulating-air mode, you can purchase the
complete installation set at specialist
outlets.
Preparing the ceiling
The ceiling must be flat and horizontal.
Ensure that the ceiling is capable of
providing a firm hold for mounting
screws and plugs. The enclosed plugs
are suitable for concrete and stonework.
If the ceiling is made of any other
material, use appropriate mounting
components.
Weight in kg:
Exhaust
air
LF457CA60 27
DIC046750 27
DIC043650 19
I94K55N0 27
LF456CA30 19
3BI845 19
3BI847 27
We reserve the right to construction changes within the
context of technical development.
Fig. 4
Recircula-
ting air
29
29
21
29
21
21
29