Wall Mount; Ceiling Mount - Grandstream GWN7610 Schnellinstallationsanleitung

Wall Mount

1. Position the mounting bracket at the desired location on the wall with
the arrow pointing up.
2. Use a pencil to mark the four mounting holes (screw holes DIA
5.5mm, reticle hole DIA 25mm).
3. Insert screw anchors into the 5.5 mm holes. Attach the mounting
bracket to the wall by inserting the screws into the anchors.
4. Connect the power cable and the ethernet cable (RJ45) to the cor-
rect ports of your GWN7610.
5. Align the arrow on the GWN7610AP with the arrow on the locking
tab of the mounting bracket and ensure that your GWN is firmly seated
on the mounting bracket.
6.Turn the GWN clockwise until it locks into place and fits the locking
tab.
4
~ 3 ~
Wall
Wall
PA3.5 x 20
PA3.5x20
Screw
Screw
Plastic Expan-
Plastic Expansion
Bolt
sion Bolt
5

Ceiling Mount

Note: Ceiling mounting is recommended for optimal coverage perfor-
mance.
1. Remove the ceiling tile.
2. Place the ceiling backing plate in the center of the ceiling tile and
mark the mounting screw holes (screw holes DIA 5.5mm, reticle hole
DIA 25mm).
3. Insert the screws through the mounting
1
4. Connect the Ethernet cable (RJ45) to the correct ports of your
GWN7610.
5. Align the arrow on the GWN7610AP with the arrow on the locking
tab of the mounting bracket and ensure that your GWN is firmly
seated on the mounting bracket and connect the network and power
cables.
6. Turn the GWN clockwise untill it locks into place and fits the locking
tab.
4
6
bracket.
Ceiling
M3 nut
Mounting
2
M3.0x50 screw
5
~ 4 ~
3
6