Inhaltsverzeichnis
Werbung
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated according to the pres-
sure exerted on the on/off switch (7). This function is very useful,
as it makes it possible to adapt the speed of the appliance to the
type of work that needs to be done.
- If the appliance works continuously at low speed, working life of the
appliance will be reduced considerably.
SPEED CHANGE
- 1st speed: Turn the selector (1 ) until it show position 1.
- 2sd speed: Turn the selector (1 ) until it shows position 2.
DRILLING, DRIVING AND IMPACT DRILLING
DRIVING:
- Turn the function selector until it points ) until the arrow on the
appliance points to ( )
- Select the torque with the torque selection ring.
- The appliance should not be in use when changing the screwing
direction.
DRILLING
- Turn the function selector (14) until points to ( ).
- To drill ALWAYS have the direction set to clockwise (CW).
- The appliance should not be in use when changing the screwing
direction.
IMPACT DRILLING
- Turn the function selector (14) until the arrow on the appliance
points to ( ).
USE:
- Select the appliance function desired. (2)
- Turn the appliance on, by using the on/off button (7)
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
- Stop the appliance by releasing the on/off switch.
- Remove the battery from the appliance if you are not intending to
Werbung
Inhaltsverzeichnis
