Connection Inside The Vehicle; Turning On; Use - Paj GPS CAR FINDER 2.0 Bedienungsanleitung

2.5 Connection inside the vehicle

The following points must be observed by all means
The Car Finder 2.0 should not be installed near
fuel lines or other combustible components in the
engine compartment.
When mounting the Car Finder 2.0, please make
sure that no other components in the vehicle are
damaged.
Installing the Car Finder 2.0 may discharge your
vehicle battery. Before connecting, check whether
your vehicle has a discharge protection and
retrofit it if necessary.
Please always observe the manufacturer's
specifications for your vehicle. Compensation
claims due to incorrect connections are hereby
excluded
Connect the Car Finder 2.0 to the appropriate socket
in your vehicle using the OBD interface. Please make
sure that the Car Finder 2.0 is inserted deep enough.
The OBD interface has no standardized position in
the vehicle. The user manual of your vehicle can
provide you with this information

2.6 Turning on

Once the activation, switching on and the transfer of
a first database has been successful, you can switch
on the Car Finder 2.0. By connecting the FINDER to
the power supply, which was previously carried out, it
has already been switched on.
uncovered locations, such as the garden or the
terrace (i. e. not inside the home, the garage, the

2.7 Use

Once the activation and switching on of the FINDER
has been successful, you can plug the FINDER into
OBD-interface and view the position of the FINDER
using a smartphone, tablet or PC. Please use our app
or go to the following website:
Car Finder 2.0 by PAJ with Online-Tracking V.1.0 EN
© PAJ UG (haftungsbeschränkt)
16
For the initial startup of the Car Finder 2.0
cellar or the like) are recommended.
www.finder-portal.com
The portal will support you step by step in its
functions.