Max Stripmax Gebrauchsanweisung

Stripmax – User manual
Foreword
The 1 channel Stripmax controller can handle all types of 12 to 24
•
V LED strips lightings.
For an optimal operation, only connect a single type of LED strip
•
to the controller.
Only in order to configure the Stripmax, an external connected
•
push-button is required.
The Stripmax is supplied by the 12 to 24 V power of the LED strip.
•
The maximum current delivered by the Stripmax can reach up to
•
6 A.
Wiring and configuration of the Stripmax RGBW
In order to get a good dimming, these steps must be carefully followed:
Plug the Stripmax according to
1.
the hereby enclosed diagram
(cut off the 230 V with the
circuit breaker first).
The different control modes
2.
can be selected with the Dmax
application available for free
on Google Play or Apple App
Store. After reconnecting the
12-24 Vdc, do a scan and then
follow the authentication
process in order to add the
corresponding Stripmax. Go to
settings and then to control
settings. For further details
about the app, see the user
guide
www.dmaxbydomintell.com
Connect the LED strip.
3.
In case you have
www.dmaxbydomintell.com
Technical data
Item number Type
5425014390230 Stripmax
• Nominal conditions: 12-24 Vdc from -10°C to 40°C.
• Maximum wiring section per contact = 1.5 mm².
• Self-resettable protection against temporary overheating.
• An exceeding of the maximum output current (max. 6 A) can
cause product dysfunctions, or even irreversible damage.
• IP20 protection level.
EN_20191906
at
a question, see the
or contact your supplier.
Voltage Output power
12 – 24 Vdc max. 1 x 6 A
Without halogen, RoHS.
•
Storage conditions: Temperature: -25°C / +70°C, Relative
•
humidity: < 75%.
For a safe installation, the device can only be installed by a
•
qualified electrician.
The device must not be opened in any case (cancels warranty).
•
The device may under no circumstances be connected directly on
•
230 V. Use a 12 to 24 Vdc transformer.
The device can only be installed inside, in a dry area, compatible
•
with IP20 norms.
During the mounting and unmounting of the device, cut off the 230
•
V circuit-breaker.
Control with a push-button (default setting)
Button:
LONG PUSH (> 0.4 s) on the button: the selected channel turns ON
(if it was turned OFF) and the dimming level slowly goes up/down
between min. and max. levels (100% = full conduction); the last
level is kept by releasing the button.
SHORT PUSH (< 0.4 s) on the button: the selected canal smoothly
turns ON or OFF.
The Stripmax complies with the following directives and norms:
Directives
RED-directive : 2014/53/UE
EMC-directive: 2014/30/UE
Norm
FAQ at
EN 60669-2-1: 2004 + A1: 2009 +A12: 2010
Stripmax
Dimension
is manufactured in Belgium by:
45 x 45 x 18
Domintell S.A.
dmaxbydomintell.com
Safety and environment
Directives and norms