Intended Use; Assembling - Wetelux Basis Bedienungsanleitung

Intended Use

This pump system is intended for outdoor use in garden ponds or fountains. The
output of the pump and the charging of the batteries depend on the solar
irradiation on the solar module.
This pump system can be installed very easily. No tools are required for assem-
bling.

Assembling

1. Install the 4 provided rechargeable batteries in the battery compartment (13).
Refer to chapter "Inserting/Replacing the batteries".
2. Put the riser pipe adaptor (7) onto the pump (12). Connect 1 to 4 riser pipe
pieces (6), as needed, and put them on the riser pipe adaptor. The set in-
cludes several sprinkler attachments (3) and a nozzle (4) which, if desired, can
be attached as a termination to the riser pipe. Put the sprinkler attachments on
the cup piece (5). If required, put the LED ring (2) on the uppermost riser pipe
(6). Connect the cable of the LED ring with the LED socket (16) on the rear of
the solar module.
3. Connect the pump (12) with the pump socket (17) on the rear of the unit.
Start-Up
9