Axis Q6055-S Installationsanleitung Seite 11

AXIS Q6055-S PTZ Dome Network Camera
How to install an SD card
Installing an SD card is optional. A standard or high capacity SD card (not included) can be used to
store recordings locally in the product.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card into the SD card slot.
3. Attach the dome cover to the top cover and tighten the screws (torque 3.2 Nm).
How to pressurize the camera (recommended)
The camera housing can be filled with Nitrogen gas to prevent condensation.
The filling process is repeated three times, releasing the pressure between fillings, to make sure that
all air and humidity is purged from the housing.
Note
The camera housing has an pressure relief valve that limits the filling pressure to 0.5 bar
(7 psi). During normal use the pressure inside the camera housing may drop below that
pressure. For full protection make sure that the pressure is above 0.2 bar (3 psi) .
1. Set the regulator gauge on the gas cylinder to 0.5 bar (7 psi).
2. Remove the caps from the inlet valve and the pressure relief valve.
3. Place the chuck on the inlet valve and press down to fill the camera with nitrogen.
4. When the pressure inside the camera housing reaches 0.5 bar (7 psi) the pressure relief
valve will open. Place your hand over the pressure relief valve to verify that the gas
is flowing out.
5. Lift the pressure relief valve to let the overpressure out of the camera unit.
6. Repeat the filling process a total of 3 times, leaving the the camera pressurized the
last time.
7. Put the caps back on the inlet valve and the pressure relief valve.
How to install AXIS T8607 Media Converter Switch
The AXIS T8607 Media Converter Switch enables the multicable to send power from the power
supply (sold separately), and to send and receive data to and from external alarm devices and
the network.
For all information on installing the AXIS T8607 Media Converter Switch, see the separate
installation guide supplied with that product.
11
EN