NGS FORTRESS 1500 V2 Gebrauchsanleitung Seite 4

USER'S MANUAL
INSTALLATION AND OPERATION
Installation for Standard UPS
1. Shut down the load (for example PC), pull out power gird.
2. Put UPS on the proper position (following the manual).
3. Connect load (for example PC) to the UPS.
4. Put the plug to the AC power socket (make sure GND is connected well).
Input
FORTRESS 2000 V2
4
Output
5. Connect to AC: press the panel switch turning on the UPS, the green LED
and yellow LED light, then you can turn on your computer etc.
6. Battery mode: press the panel switch turning on the UPS, the red LED
lights, then you can turn on your computer etc.
7. Normally turning UPS: press the panel switch turning on the UPS.
8. Normally turning off UPS: press the panel switch turning off the UPS.
Circuit breaker
FORTRESS 1500 V2
Input
Output