HIKVISION DS-PD2-D15AME Installationsanleitung

DS-PD2-D15AME/D15AME1
15m Dual T -Mask Detector
EN50131-2-4:2008
EN50131-1:2006+A1:2009
Security Grade (SG) 3
Environmental Class (EC) II
Diagram references
detect when both PIR and Microwave technologies are Masked. The detector is
sensors.
The Mask is adjustable between 0 to 1M.
If the Masking area is entered the Blue LED starts flashing to show that the
MASK and ALARM relay will open and the Green and Orange LEDs will be
and a walk test must be done.
Blocking:
15m when the panel is disarmed. When blocking is detected the alarm relay
blocking, the DS-PD2-D15AME must be walk tested so that the PIR and MW sensors
Blocking Enabled/Disabled: To enable the feature, switch 6 must be OFF
and the RI input should be connected to an output on the control panel which
gives 0V when DISARMED and removes 0V when ARMED.
DS-PD2-D15AME is supplied with the following:
BRACKETW (Wall Bracket), BRACKETC (Ceiling Bracket) and TAMPER
(Rear tamper)
D NOTE:
remains at 15m.
Coverage 85° ,60 zones and 7planes, default
Maximum Range 15m/18m/30m(included)
Op mal Installa on Height 1.8-2.4m
Creep-Zone Protec on Yes
Key Features
Adjustable An -Masking (An -Spray) Yes
An Blocking Technology Yes
Blue Wave Technology Yes
Automa c Sensi vity Yes
Digital Temperature Compensa on Yes
Separate Indica on: Microwave, PIR and Alarm LED Colors: Orange (Microwave), Blue (Alarm), Green (PIR)
3 icrowave Frequencies to Avoid Interference Yes
DEOL Resistors on Board Yes
Tamper Protec on Included Front, rear, and bracket tamper signal input
Wired
Power Supply 9-16 VDC (12VDC nominal)
Current Consump on at Rest 23mA
Current Consump on in Alarm 30mA
Relay Type Solid state
Output Relay 60VDC, 50mA protec on
Tamper Terminal 12VDC max, 50mA max
Electrical Specifica ons
10.515, 10.525, 10.535 GHz
Microwave Frequency
9.89, 9.90, 9.91 GHz
Alarm Response 2.5 seconds
Detec on Speed 0.3 - 3m/s
Op cs Sealed
Geometric Lens Configura on 3D
Other Details
Opera ng Temperature -10°C to +40°C
Weight 125g
Dimensions(H x W x D) 117 x 69 x 50 mm
Accessories
Wall/Ceiling Brackets Included Yes
Long Range and Curtain Lenses Included Yes
Bracket Back Tamper Kit Included Yes
User Manual
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
ALL RIGHTS RESERVED.
ALL RIGHTS RESERVED.
wholly, by any means, without the
or implied, regarding to the Manual.
About this Manual
This manual is applicable to video security control panel.
About this Manual
This manual is applicable to detector.
Please use this user manual under the guidance of professionals.
Trademarks Acknowledgement
website
For electrical products sold within the European Community. At the end of the electrical
Please use this user manual under the guidance of professionals.
products life, it should not be disposed of with household waste. Please recycle where
Trademarks Acknowledgement
country. This product operates in a European non-harmonised frequency band. Hereby
This product and - if applicable - the supplied accessories too are marked with "CE"
at www.pyronix.com/product-compliance.php
and comply therefore with the applicable harmonized European standards listed
Commercial and Light Industrial Environment.
START
3EOL
A A T T
EOL INPUT 1 COM
1M
MAX
Max: 1M
30% Mask
≤1m
Hangzhou Hikvision Digital Technology CO.,Ltd.
MASK/ALARM EOL
LINK
N/C
DEOL
A A T T
A A T T
EOL INPUT 1 COM
EOL INPUT 1 COM
NOTE: The mask
adjustment needs to be
30%
set to half way to
comply with
EN50131-2-4.
OFF
>1m
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
!
The Input voltage should meet both the SELV (Safety Extra Low Voltage) and
the Limited Power Source according to the IEC60950-1 standard. Please refer
to technic cations for detailed information.
GENERAL WIRING
HIK
GENERAL
HIK CONTROL PANEL
GENERIC CONTROL PANEL
Z1 COM Z2 Z3 Z1 COM Z2 Z3
10.525GHz 10.515GHz
10.525GHz
10.525GHz