Philips HD7450 Bedienungsanleitung Seite 2

EnGlIsh
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit
from the support that Philips offers, register your product at www.philips.
com/welcome.
General description (Fig. 1)
A Permanent filter (specific types only)
B Removable filter holder
C Removable water tank cover
D Water tank
E Water level indicator
F Lid of jug
G Jug
H On/off switch
I Hotplate
J Mains cord with plug
K Coffeemaker
L Lid of coffeemaker
Important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
- Never immerse the appliance in water or any other liquid, nor rinse it
under the tap.
Warning
- Check if the voltage indicated on the appliance corresponds to the local
mains voltage before you connect the appliance.
- Do not use the appliance if the plug, the mains cord or the appliance
itself is damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
- Children should be supervised to ensure that they do not play with the
appliance.
- Keep the mains cord out of the reach of children. Do not let the
mains cord hang over the edge of the table or worktop on which the
appliance stands.
Caution
- Do not place the appliance on a hot surface and prevent the mains
cord from coming into contact with hot surfaces.
- Unplug the appliance if problems occur during brewing and before you
clean it.
- This appliance is intended to be used in household and similar
applications such as:
- staff kitchen areas in shops, offices and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
- Wait until the appliance has cooled down before you store it, especially
if you want to push the mains cord into the appliance. The hotplate and
the coffee jug may be hot.
- Beware of hot steam when you open the lid of the coffeemaker.
- The jug is hot during and after brewing. Always hold the jug by its
handle.
- Never use the jug in a microwave oven.
- Do not move the appliance while it is brewing coffee.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic
fields (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientific evidence
available today.
Before first use
Place the appliance on a flat and stable surface.
1
Push excess cord into the opening in the back of the appliance. To fix
2
the cord, push it into the narrow part of the opening (Fig. 2).
Note: Make sure that the cord does not come into contact with hot surfaces.
Put the mains plug in an earthed wall socket.
3
Clean the detachable parts (see chapter 'Cleaning').
4
Reassemble all parts.
5
2
- Make sure the water tank cover is placed correctly ('click') (Fig. 3).
- Make sure the filter holder is placed correctly. First place the back of
the filter holder under the rim of the hinge (1) and then push down the
handgrip (2) until the filter holder locks into place (Fig. 4).
Note: If the filter holder is not placed correctly, the lid cannot be closed.
Flush the appliance (see section 'Flushing the appliance' below).
6
Flushing the appliance
Note: Do not put a filter and ground coffee in the filter holder.
Open the lid of the coffeemaker (Fig. 5).
1
Fill the water tank with fresh cold water up to the MAX
2
indication (Fig. 6).
Note: Do not switch on the appliance when the lid is still open.
Close the lid.
3
Put the jug on the hotplate (Fig. 7).
4
Note: Make sure you put the jug on the hotplate with the spout facing into the
appliance.
Press the on/off switch to switch on the appliance (Fig. 8).
5
The power-on light goes on.
,
Let the appliance operate until all the water has run into the jug.
6
Switch off the appliance. Let it cool down for at least 3 minutes
7
before you start brewing coffee.
Using the appliance
Open the lid of the coffeemaker (Fig. 5).
1
Fill the water tank with fresh cold water up to the required
2
level (Fig. 9).
- The indications on the left side of the water level window correspond
to large cups (120ml).
- The indications on the right side of the water level window correspond
to small cups (80ml).
Make sure the filter holder is placed correctly. First place the back of
3
the filter holder under the rim of the hinge (1) and then push down
the handgrip (2) until the filter holder locks into place (Fig. 4).
Note: If the filter holder is not placed correctly, the lid cannot be closed and the
drip stop cannot function properly. The drip stop prevents coffee from dripping
through the filter onto the hotplate when the jug is removed.
Take a paper filter (type 1x2 or no. 2) and fold the sealed edges to
4
prevent tearing and folding (Fig. 10).
Note: Some versions come with a permanent filter. In this case you do not need
to use paper filters.
Put the paper filter or the permanent filter in the filter
5
holder (Fig. 11).
Put ground coffee (filter-fine grind) in the filter (Fig. 12).
6
- For large cups: use one heaped measuring spoon of ground coffee for
each cup.
- For small cups: use one level measuring spoon of ground coffee for each
cup.
Close the lid of the coffeemaker. (Fig. 13)
7
Place the jug with the lid closed on the hotplate (Fig. 7).
8
Note: Make sure you put the jug on the hotplate with the spout facing into the
appliance. If the spout of the jug sticks out from under the filter holder, the
coffee may cool down.
Note: If you do not place the jug properly on the hotplate, the drip
stop prevents the coffee from flowing into the jug. This may cause the filter to
overflow.
Press the on/off switch to switch on the appliance (Fig. 8).
9
The power-on light goes on.
,
Let the water pass through the filter into the jug.
10
Note: If you want to remove the jug during brewing, the drip stop prevents
coffee from dripping through the filter onto the hotplate. Place back the jug as
soon as possible to prevent the filter from overflowing (Fig. 14).
You can leave the jug on the hotplate to keep the coffee warm and to
11
preserve its flavour.
Note: Make sure you put the jug on the hotplate with the spout facing into the
appliance. If the spout of the jug sticks out from under the filter holder, the
coffee may cool down.
After use, press the on/off switch to switch off the appliance.
12
Note: The appliance does not switch off automatically.
Note: If you want to brew another jug of coffee right away, let the appliance
cool down for 3 minutes first.
4222.200.0401.1