Danelectro Dan-O-Matic DT-2 Bedienungsanleitung Seite 4

3
If the needle stops to the right of the "0" the note is sharp
(#). Adjust instrument tuning and play the note again.
Repeat until the meter needle lines up under the "0" on the
meter. The note is then in tune.
4
The 3 LED's will light as follows:
• ( ) The note is -1 to -50 cents below correct pitch.
• (TUNE) The note is in tune.
• (#) The note is +1 to +50 cents above correct pitch.
If the ( ) LED lights, follow instructions in no. 2 above.
If the (#) LED lights, follow instructions in no. 3 above.
5
If the note played is greater than -50 or +50 cents from true
pitch, adjust instrument tuning until one of the LED's
lights.
6 The DAN-O-MATIC
faster acting than many other tuners. On some notes or
instruments, the needle on LCD meter may move rapidly
from one reading to another. If this happens, try playing the
note more softly.
7
When needle fades, replace battery with S006P 9 volt
battery.
8
The tuning functions of DT-2 can be powered with a 9 volt
battery. However, the meter will not be lighted unless you
use a 9 volt battery eliminator (center negative, 300mA
4
™ is more sensitive and the meter is
maximum). We recommend Danelectro DA-1 adaptor. If
using battery eliminator, it will power both the tuning func-
tion and meter light.
9
The DAN-O-MATIC ™ can be used "in line" without affect-
ing instrument sound.
BATTERY: Uses one S-006P 9-Volt Battery. Danelectro battery recommended.
Battery Eliminator: Uses 9-Volt battery eliminator. Polarity: Center negative (–) adaptor
plug. 300mA maximum. Danelectro Zero Hum ™ DA-1 Adaptor is recommended.
5