Mounting And Operating Instructions; General Informations - aqua metro AMFLO SONIC DryX Montage- Und Bedienungsanleitung

General Information
The AMFLO ® SONIC DryX is a flow meter. Flow is measured using ultrasound. The device consists of a number of components, so special
care is required during mounting, installation and commissioning.
The device is a precision measurement instrument and must be handled with care. Improper use could damage the
device and invalidate the warranty.
Safety instructions
Designed use
This unit is designed for acquisition, calculation, displaying and sending datas. Resulting from incorrect use or from use other than that
designated, can suspend the operational safety of the devices. The manufacturer accepts no liability for damages being produced from this.
Installation, commissioning and operation
Installation, connection to the electric supply, commissioning and maintenance of the device must be carried out by trained, qualified
specialists authorized to perform such works. The specialist must have read and understood these Operating Instructions and must follow
the instructions they contain. The installer must ensure that the measuring system is correctly wired in accordance with the wiring diagrams.
Before working on electrical installation, make sure to disconnect the power supply and ensure that nobody can reconnect it without your
permission.
Pay attention to the following points:
• Voltage, operation data
• Maximum transmission length
• Cable cross section, length
• Ambient temperature and mounting position
Operational safety
The manufacturer reserves the right to modify technical data without prior notice. Your local distributor will supply you with current infor-
mation and updates to these Operating Instructions.
Return of the instruments
The following procedures must be carried out before a device requiring repair or calibration, for example, is returned to Aquametro:
Always enclose a fully completed "Repair Form" with the device. Only then Aquametro can transport, examine and repair a returned device.
Notes on safety conventions and icons
The devices are designed to meet state-of-the-art safety requirements. They have been tested and left the factory in a condition in which they
are safe to operate. They can, however, be a source of danger if used incorrectly or for use other than the designated use. Consequently,
always pay particular attention to the safety instructions indicated in
these Operating Instructions by the following symbols:
Warning!
"Warning" indicates an action or procedure which, if not performed correctly, can result in injury or a safety hazard.
Comply strictly with the instructions and proceed with care.
Caution!
"Caution" indicates an action or procedure which, if not performed correctly, can result in incorrect operation or
destruction of the device. Comply strictly with the instructions.
Note!
"Note" indicates an action or procedure which, if not performed correctly, can have an indirect effect on operation or
trigger an unexpected response on the part of the device.
AMFLO SONIC DryX
® 9