Werbung
Verfügbare Sprachen
Verfügbare Sprachen
in contact with water.
Operation
The voltage of the power source must comply with the specifications on the name plate
of the heater. Devices marked with 230 V can also be operated with 220 V. Before
operation it is imperative to make sure that the installation location corresponds to the
requirements of the safety instructions.
Insert the power plug into an earthed outlet.
Note: Please observe that the power plug must still be able to be reached after
installation of the electric fireplace insert.
Your electric fireplace insert is now ready for operation.
Switching flame simulator on / off
Note: You can also switch on the flame simulator when you are not using the heating
function.
Note: Power consumption of the electric fireplace insert with illumination switched on but
without heating function amounts to approx. 2 W.
Set the ON / OFF switch 5 to position I.
Set the ON / OFF switch 5 to position 0 if you would like to turn off the flame simulator.
Switching heating function on / off
Note: The electric fireplace insert has 2 heating stages with different heat intensities.
Note: When the heater is turned on for the first time, a slight, harmless odour can
develop. This odour develops due to the heating up of the inner heating elements.
Provide sufficient ventilation.
Set the ON / OFF switch 5 to position I.
Set the switch for the first heating stage 6 to position I if you would like a low supply of
heat (750W). Set the switches 6 and 7 to positions I and II for the first and second
heating stages if you would like a high supply of heat (1500W).
Note: You can only put the second heating stage into operation if the switch 6 for the
first heating stage is set to position I.
ATTENTION! DANGER OF BURNING! Please observe that the surfaces which radiate
heat can achieve temperatures exceeding 50 °C. Make sure that the unit is switched off
and cooled off before you touch it.
ATTENTION! Please make sure that the unit is not covered with towels, curtains or
similar objects.
Otherwise there is danger of overheating. Therefore, always pay attention that the
entilation slots are kept clear.
Flip the switches for the first heating stage 6 and the second heating stage 7 back in
order to turn of the heating function.
Set the ON / OFF switch 5 to position 0 if you would like to turn off the flame simulator
also.
Maintenance and cleaning
WARNING! DANGER TO LIFE BY ELECTRIC SHOCK! Before conducting cleaning or
maintenance work please pull the power plug out of the outlet and let the unit
Werbung
Kapitel
