Werbung
DDL/DSL Installation Guide
● Self EDID Detecting
You can change factory setting of resolution due to connect other monitors as following orders.
1. Power on your display.
2. Connect transmitter to the DVI of display.
3. Plug DC power in to the transmitter.
4. Check if LED blinks rapidly for a few seconds. EDID is well acknowledged once the blinking stops.
5. Connect transmitter to the PC and receiver to the display. Then please plug the DC power in to
the receiver.
6. Connect the optical fiber between transmitter and receiver. Using multimode optical fiber is a
must.
7. Restart your computer.
※ If transmitter's power LED doesn't light up, please plug the DC power adapter for transmitter.
● Caution
Use the DC adapter (5V, 2A) included in the product for the receiver, which is connected to
the monitor and requires the external power supply. The transmitter connect-ed to the computer
normally used the computer power. Therefore, no external DC adapter is required except some
computers with the special specification. In this case, use the external DC adapter used for the
receiver.
(Connect transmitter to adapter only in case of either insufficient internal power or no power from
computer. Double power supplying may cause damages to the product.)
4
DDL_DSL.indd 4
2011-09-28
10:07:07
Werbung
