Alemite 343289 Serviceanleitung

Description
Model 343289 Battery Charger is designed to charge the 20 Volt
battery packs (343291) of cordless grease guns. The charger's power
source is a standard automotive 12-24 Vdc accessories outlet.
Specifications
Input
12 Vdc - 24 Vdc 20 Vdc (1.0 Amps)
SAVE ALL WARNINGS AND INSTRUCTIONS FOR
FUTURE REFERENCE – Before using the Battery Charger
read all instructions and cautionary markings on the
Charger, battery pack, and products using the battery pack.
To reduce the risk of injury, charge only Lithium-ion type
rechargeable batteries. Other types of batteries may burst
causing injury to persons or damage to property.
Safety of others
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Do not expose the Charger to rain, snow, or frost.
To reduce the risk of damage to electric plug and cord, pull
by the plug rather than the cord when disconnecting the
Charger. Do not abuse the cord. Never carry the Charger by
the cord.
Make sure the cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or stress.
Do not operate the Charger with a damaged cord or plug.
Do not operate the Charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way.
Do not disassemble the Charger.
Do not attempt to charge any other cordless tool or battery
pack with this Charger.
Do not charge the battery pack in a damp or wet location, or
when the temperature is below 32°F (0°C) or above 104°F
(40°C).
Do not store the Charger assembly in locations where the
temperature is below -4˚F (-20˚C) or above 185˚F (85˚C).
167 Roweland Drive, Johnson City, Tennessee 37601
671062
Service Guide
Mobile Battery Charger
Output Cord Length
6 feet (1.8 m)
WARNING
CAUTION
Alemite, LLC
www.alemite.com
©
Copyright 2014 by Alemite, LLC
Battery Charger Operation
Make sure power circuit voltage is same as that shown
on the charger specifications plate. Ensure the Battery
properly engages with the charger's contacts.
Function of Red and Green Lights
When the charger is powered on, the Green light
will flash one time.
Green light flashing
Charging
Green Light On
Battery fully charged
Red Light Flashing at 4HZ
Bad Battery condition. The Charger has the
ability to detect a weak or damaged battery. If
this LED function occurs, do not continue to
charge the Battery. Return it to a service center
or a collection site for recycling.
Red Light Flashing at 1HZ/5HZ
Hot/Cold Battery. When the Charger detects that
a Battery is excessively hot or cold, charging is
suspended until the battery has normalized. Once
battery is at a temperature between to 40° F (4°
C) and 104° F (40° C), the charger automatically
switches to Charging mode. Battery overheating
could be attributed to:
A. Long continuous running
B. Hot ambient temperature
C. One or more cells are damaged
The Battery will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
343289
SER 343289
Revision (07-14)