Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Torque wrench
Artikel-Nr.
03940L-IMP
Bereich Nm
100 - 500
Antrieb
20 (3/4)
Einteilung
2,5
HOW TO USE
A. Balancing wrench in hand with graduations visible with the marked arrow elementary
Scale up
then unlock knurled handle by pulling sleeve.
B. Set amount of torque required by turning knurled handle to read exact
amount on case graduations.
EXAMPLE: 56ft .Lbs
1. Turn knurled handle until the zero graduation on the bevel edge of the
knurled handle is lined up with the vertical mark on the case and is even with
the 50 ft .Lbs graduation.
2. Turn knurled handle clockwise until 6 ft.Lbs graduation on the level edge of
the handle is in line with the vertical line on the case.
3. Lock handle securely by pushing sleeve, and now wrench is set at 56 ft , Lbs
which is ready to use .
C. lnstall the proper socket or attachmant to the square drive and apply to nut or
ball and pull handle until you feel and / or hear wrench click. Release pull and
wrench automatically resets for next operation.
Do not continue to pull after wrench releases. Use special care at low torque
settings that will pull stop when wrench clicks.
CAUTION
1. If wrench has not been used or has been in storage for some time, operate it several
times at a low torque setting which permits special internal lubricant to re-coat internaI
working parts.
2. When wrench is not in use, keep doing adjustment at lowest torque setting.
3. Do not turn handle below lowest torque setting.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
03941L-IMP
03942L-IMP
140 – 700
140 – 980
20 (3/4)
20 (3/4)
2,5
2,5
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
03950L
140 - 980
25 (1)
7,0
www.swstahl.de
Werbung
