Alcatel - Jabra LINK 14201-20 Anleitung

AlCATEl

desK PhoNe - headset comPatibility
The Jabra LINK is compatible with a wide range of Alcatel phone
models. please see below which of the supplied cables you would
need for each supported model:
Alcatel.iP.touch.Extended.Edition.Cable.Matrix
- cable marked: D white
4028 EE .
- cable marked:
4038 EE .
- cable marked:
4068 EE
- Telephone cable*
* Telephone cable supplied with your headset.
for the latest compatibility update please visit:
http://www.jabra.com/Alcatel
8
red (Already plugged in)
orange
To.install.your.Jabra.liNK.solution
. settings:
1. Install your headset solution to your desk phone according to the
headset manual.
2. Set "clear dial tone switch" in "A" position - see headset manual.
3. Ensure your headset base unit EHS mode is setup to Dhsg -
see headset manual*.
. Connections:
4. with the cable included with your headset system, connect the
phone socket on your headset base unit to the phone socket on
your Jabra Link.
5. with the cable marked white
socket on your Jabra LINK to the 3,5 mm headset socket on the
side of your desk phone.
6. with the cable marked orange
on your Jabra LINK to the modular socket on your desk phone
marked with a "bell" icon.
7. with the cable marked red
headset base unit to the Jabra LINK AuX socket.
Note: The marked end of each cable must be connected to the Jabra LINK.
* If your base unit does not support.Dhsg mode, rHL mode (gN default AuX mode) can be
used with limited functionality between phone and base unit – which means under installation
you may need to do hook oN and off a couple of times before phone and base/headset are in
sync. for rHL mode we recommend either to use your headset or phone to answer/end calls.
D , connect the Headset / Handset
, connect the coM socket
, connect the AuX socket on your
9